Skip to Store Area:

Visual Edge

(858) 643-9020

You have no items in your shopping cart.

Visual Edge Slant Board Leg Removal and Replacement Instructions

Visual Edge Slant Board Leg Removal and Replacement Instructionsslant board leg removal

TOOLS REQUIRED

Drill with ¼” bit
Flat head screwdriver
Pliers (Needle Nose Preferred)

ITEMS ENCLOSED

1 Set of Instructions
1 Plastic Leg Mounting Unit
End Cap
2 Round Head #8 x 5/8” Bolts
2 Hexagonal #8 Nuts

REMOVAL INSTRUCTIONS

1) On a level stable surface place the Slant Board face down. With the drill and ¼” bit
carefully drill out the end of both rivet stems to just below the washer.
2) With the pliers grab the outside of the washer and pull both washers off.
3) Grasp the plastic leg-mounting unit and gently pull away from the board.
4) If there is some resistance removing the leg-mounting unit, with the pliers crimp the rivet stem into a point and reattempt pulling the leg-mounting unit off.

INSTALLATION INSTRUCTIONS

1) Place the plastic leg into the slot on the leg-mounting unit with the spacing peg facing up.
2) Turn the two pieces over, placing them on the backside of the Slant Board and align the new leg-mounting unit with the holes
on the Slant Board. Hold in place with your hand.
3) From the front side of the Slant Board insert the bolts through the holes in the board and leg-mounting unit.
4)From the backside of the Slant Board screw on the nut and tighten with your fingers.
5) With the pliers firmly hold the nut on the backside of the Slant Board and with the
screwdriver tighten the bolts from the front.
Slant Board Pens

YOUR VISUAL EDGE SLANT BOARD

IS NOW READY TO USE!

IF YOU HAVE ANY QUESTIONS OR DIFFICULTIES WITH YOUR INSTALLATION
PLEASE EMAIL US AT SALES@VISUALEDGESB.COM
Leave a Reply