Skip to Store Area:

Visual Edge

(858) 643-9020

You have no items in your shopping cart.

Slant Board Paper Catch Removal and Replacement Instructions

Visual Edge Slant Board Paper Catch Removal and Replacement Instructions

slant board paper catch removal

TOOLS REQUIRED

Drill with ¼” bit
Flat head screwdriver
Pliers (Needle Nose Preferred)

ITEMS ENCLOSED

1 Set of Instructions
2 Round Head #8 x 3/8” Bolts
2 Hexagonal #8 Nuts
2 #8 Lockwashers

REMOVAL INSTRUCTIONS

1) On a level stable surface place the Slant Board face down. With the drill and ¼” bit carefully drill out the end of both rivet stems to just below the washer.
2) With the pliers grab the outside of the washer and pull both washers off.
3) Turn Slant Board over and gently pull the broken paper catch off.
4) If there is some resistance removing the paper catch, turn the Slant Board back face down and with the pliers crimp the end of the rivet stem into a point and reattempt pulling the paper catch off.
slant board leg removal

INSTALLATION INSTRUCTIONS

1) Align the new metal paper catch with the holes on the front side of the Slant Board.
2) Insert the bolts through the paper catch and Slant Board from the front side.
3) From the backside of the Slant Board first place the lockwasher onto the bolt, then screw on the nut and tighten with your fingers.
4) With the pliers firmly hold the nut on the backside of the Slant Board and with the screwdriver tighten the bolts from the front.
YOUR VISUAL EDGE SLANT BOARD IS NOW READY TO USE!
Leave a Reply